WORKING WITH THE
MACHINE
6.2.6. SETTING VALUES FOR THE LOWER CHEEK
AND BENDING CHEEK
Refer to
Section 6.2.7 "ADJUSTING PROGRAMMABLE
LOWER CHEEK AND BENDING
CHEEK"
for machines with motor-driven lower cheek
adjustment
(special
version).
Observe Section 6.1
"OCCUPATIONAL
SAFEW
DIREC-
TIVES' under all circumstances.
ATTENTION!
Observe the following
under all circumstances for adjust-
ment
work,
in order to
prevEnt
collisions:
When moving downwards,
always bring the bending cheek
to the common sefting
first, followed by
the
lower
cheek
When
moving upwards, always move the lower cheek to the
common
setting first, followed by the bending cheek.
The lower cheek
and bending
cheek
must always be set with respect to the
point
of rolation
in
the conect
order before
starting bending work
on the folding machine.
This depends
on the
thickness of the sheet
to be bent or on the respective radius and sheet
thickness when bending with radius rails.
i
i
I
i
i
I
l
I
:_
I
I
t-
:'
:
RAS 74.20-40
MULTIBEND
9OOO
S€ptember
7, 1 993
6-11
To Next Page
Loading...