4 | Transport
22 / 72 80.06.231_iVarioProL-iVarioProXL_IM_en-GB
7. If you set up the unit without a substructure, remove the transport feet
prior to installation.
>> The unit is standing on its intended installation surface and is ready for as-
sembly and installation.
4.3 Transport with pallet
CAUTION
Inclinations when transporting with a transport aid
Risk of crushing and injury during transport with a transport aid over
inclinations or uneven floors.
n
Do not go over an incline of more than 10°.
n
Transport the unit carefully.
a The packaging material is removed.
a The pallet truck is at the lowest setting.
1. Place the transport aid on the side of the electrical compartment.
2. Transport the unit to its place of installation with the transport aid.
3. Lift the unit at the lifting points and place it on its intended installation sur-
face.
>> The unit is standing on its intended installation surface and is ready for as-
sembly and installation.
To Next Page
Loading...
