Rational iVario Pro XL - Setting up the Device; Device Alignment

5 | Setup
28 / 64 80.06.243_iVarioProL-iVarioProXL_IM_en-US
5.2 Setting up the device
CAUTION
Risk of tipping when setting up on the installation surface
Risk of crushing if the device tips over onto a person.
n
Note the center of mass of the device.
n
Ensure that the device does not tip over during lifting.
a The installation surface is horizontal.
a The minimum distances are observed.
1. Position the device on the designated installation surface.
>> The device is positioned on the installation surface and ready for horizon-
tal alignment.
Setting up the device without base
a The installation surface is horizontal.
a The minimum distances are observed.
a The transport feet have been removed.
1. Position the device on the designated installation surface.
>> The device is positioned on the installation surface and ready for horizon-
tal alignment.
5.3 Device alignment
The horizontal alignment of the device takes place via the device feet.
NOTE
The pan is not on the pan stops
On leaving the factory, the plan is on the pan stops. Do not adjust these
screws.