9 | Waste water connection
50 / 64 80.06.243_iVarioProL-iVarioProXL_IM_en-US
9.2 Connecting the wastewater drain
n
The wastewater connection is located on the rear side of the device.
n
Diameter on the device drain: DN 50 mm
Installing the drain to the rear side of the device
a The drain pipe is designed for a DN 50 mm device drain.
a The drain pipe corresponds at least to type PP and is steam temperature
resistant.
1. Use a 90° elbow as the first and T-piece as the second pipe piece for the
drain pipe.
2. Avoid unnecessary 90° angles in the pipework to ensure optimal water
drainage.
3. Connect the drain pipe to the side or leading downwards.
4. Observe a minimum distance of 20 mm [3/4 Inch] between the drain
channel and waste water drain. The manufacturer recommends a minimum
distance of 50 mm [2 Inch] to make cleaning easier.
5. When connecting the drain pipe in the wall, the installation altitude must
be between 150–300mm [5 7/8–11 3/4 inch].
20 mm [3/4 Inch]
5%/3°
150–300 mm
[5 7/8–11 3/4 Inch]
>> The drain pipe is installed with an incline of at least 5% or 3°.
To Next Page
Loading...
