LAN cable connection
182 / 203
How to connect a LAN cable to the LAN interface of your appliance is described below.
The LAN interface is on the
underside of the appliance,
on the left side (on the right
of the rear panel for XS
models).
Unscrew the splash
protection cover.
Fit all individual parts onto
the cable, as shown in the
diagram.
Then plug the LAN cable
into the port.
Now screw all the individual
parts of the splash
protection cover.
Please now reassemble all
components (starting from
the appliance).
The components must be
assembled sturdily without
the use of tools so as not to
damage components and
seals.
NOTE:
If seals are damaged,
splash protection may no
longer be functional.
Danger of burns.
When laying the LAN cable underneath the unit floor, please make sure that it does not come
into contact with hot components.
Do not wrap the LAN cable around hot components.
To Next Page
Loading...
