7. Unplug the heater when not in use.
8. The power cord should not touch the heater when it is on.
9. Never use the device outside.
10. Do not leave the device unattended when in use.
11. Contact the manufacturer or technical service in the case of a leak.
12. When disposing of the device follow regulations applicable to disposal of oil.
13. It is normal for the heater to emit some odor when it is turned on for the first time. When using the heater for the first
time, set it to maximum power for two hours and open a window to let the smell of the new device out.
INSTALLATION OF THE CASTERS
1. Turn the heater upside down and put it on a soft surface to prevent scratching of its surface.
2. Screw caster disc to the heater with the wire and wing nuts.
3. Push each caster on pins on the disc until they click in the right place.
4. Turn the heater back to the upright position.
WARNING: Do not operate without feet attached. Do operate the heater only in upright position (feet on the bottom, controls
on the top), any other position could create a hazardous situation.
OPERATION
ATTENTION!
Make sure that the power source to which the appliance is to be connected is accordant with the parameters specified on the
rating plate.
1. Choose a suitable location for the heater, taking into account the safety instructions above.
2. Insert the plug of the heater into a suitable outlet (220-240V).
3. Turn the thermostat knob clockwise until you feel detectable resistance.
4. Switch the device on following the guidelines below. After the power level switches are on, diodes will light up.
• The minimum heating power - press left switch I
• The medium heating power - press right switch II
• The maximum heating power - both switches I and II must be on
5. To reduce the maximum heating power, turn off one of the interim powers - the minimum or medium one.
6. You can control heating intensity for the selected heating power, turning the thermostat leftward (without switching it
off) or rightward to MAX position.
7. To turn the device off, turn off the power switches, turn the thermostat to "0" level (off) and unplug the device.
MAINTAINING THE PRESET TEMPERATURE
1. When switching the device on, the thermostat knob should be set to the maximum level until the required temperature
is reached.
2. After the required temperature has been reached, turn the thermostat knob slowly counterclockwise until a red lamp
goes out.
To Next Page
Loading...
