Need help?Do you have a question about the Rave Sports Bongo 10-Foot and is the answer not in the manual?
General| Brand | Rave Sports |
|---|---|
| Model | Bongo 10-Foot |
| Category | Boat |
| Language | English |
Lay the Bongo on a flat surface, ensuring no sharp objects are underneath to prevent punctures.
Locate the Bongo valve, unscrew the cap, and prepare for inflation using recommended tools.
Instructions for using the special inflation adaptor with the RAVE Sports High Speed Inflator.
Inflate until firm, check pressure, and heed the caution against over-inflation to prevent damage.
Orient the ladder stabilizer on the top two ladder steps with the curved portion facing upwards.
Line up the large opening of the keyhole slots with the four bolts on the underside of the top two steps.
Slide the stabilizer to engage bolts in the narrow end of the slots, tap to ensure they are fully engaged.
Attach the ladder to the center of the blue panel using the quick link and webbing around the lacing rope.
Ensure the quick link connection is covered by the top webbing strap, with straps as parallel as possible.
When properly installed, the ladder will hang with the curved portion of the stabilizer against the underside of the Bongo.
Attach an anchoring device to the ring or mount on the inner surface of the tube, opposite of the ladder.
Store the inflatable in a covered, shaded area, protected from UV rays and damage.
Clean with mild soap and fresh water; never use petroleum products, solvents, or power washers.
Ensure the product is completely dry before rolling loosely and placing it in a protective container.
Tips to deter rodents, including maintaining air pressure and removing food sources.
Contact RAVE Sports Customer Service for large holes, tears, or seam failures.
Steps for patching minor holes, including cleaning, applying glue, and drying the patch.
To Next Page
