CHAPTER
2
Manual No. 016-1001-063 Rev. E 5
CHAPTER 2
INTRODUCTION
INTRODUCTION
Congratulations on your purchase of the Raven AccuBoom system! This system is designed to provide accurate
and cost-efficient application control by avoiding no-spray zones and eliminating wasteful overlaps.
This manual applies to the following machines. For future reference write your serial number in the space below.
MAKE: RoGator & TerraGator
MODEL: RoGator Liquid/AirMax 180, TerraGator Liquid/AirMax/AirSpread
FIGURE 1. RoGator
PREPARING FOR INSTALLATION
Before installing AccuBoom, park the machine where the ground is level, clean, and dry. Leave the machine
turned off for the duration of the installation process.
During the installation process, follow good safety practices. Be sure to carefully read the instructions in this
manual as you complete the installation process.
RECOMMENDATIONS
Raven Industries recommends the following best practices before installing or operating the AccuBoom system for
the first time, at the start of the season, or when moving the AccuBoom system to another machine:
To Next Page
Loading...
