Raven AccuBoom - Page 3

CHAPTER
1
INTRODUCTION
____________________________________________________________
Congratulations on your purchase of the Raven AccuBoom system! This
system is designed to provide worry free turn on and turn off of your
booms with respect to the as-applied coverage map. The following
instructions are designed to assist you in the proper installation of the
AccuBoom system. See the Viper Installation and Operation Manual for
instructions on setting up the software and using the AccuBoom system.
You will also need a valid AccuBoom Control activation key for your
Viper in order to activate the AccuBoom system.
Important! All boom switches must remain in
the OFF position while AccuBoom control is
in operation!
COMPONENTS
NEEDED
• Kit, Parallel Accuboom 3000/4000 Series SpraCoupe including:
• Parallel AccuBoom Control Node – P/N 063-0172-517
• 5-Channel Driver – P/N 063-0172-753
• Spra-Coupe 3000/4000 Series AccuBoom Cable – P/N 115-0171-
598
• AccuBoom Control Activation Key – P/N 077-0180-010
• Spra-Coupe 3000/4000 Parallel AccuBoom Installation Manual –
P/N 016-0171-013
Manual #016-0171-013 Rev. C 01/07
1