5
Manual No. 016-0230-004 Rev. F 67
UltraGlide
1. Mount the sensor bracket to the front-right side of the machine’s center rack using two 3/8”-16 UNC x 1” hex
bolts (P/N 311-0054-105) and two 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164) as shown in Figure 11
above.
2. Tighten the nut to ensure the sensor is mounted securely.
Connect the Sensor Cables
1. Connect the left sensor cable (P/N 115-0171-527) to the connector on the left sensor.
2. Route the left sensor cable toward the AutoBoom valve.
3. Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.
4. Repeat the steps above to connect the remaining sensor cable(s).
Note: The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.
To Next Page
Loading...
