Manual #016-0171-081 Rev. B 07/08
CHAPTER
3
CAN INSTALLATION
________________________________________________________________________
If the machine you are working on does not currently have a Raven CAN
system, you will need a Kit, CANbus, Terminators & Power Adapter “T”
P/N 117-0159-923. This kit contains the CAN Cable Adapter Tee With
Power P/N 115-0171-368 and two(2) CANBus Terminators P/N 063-
0172-369. To install a Raven CAN system:
1. Connect CAN Tee to power and ground.
a. Locate a convenient source of power and ground near the control
system.
b. Connect the red wire of the CAN Cable Adapter Tee With Power
P/N 115-0171-368 to a source of clean 12 volt power.
c. Connect the white wire from the CAN Cable Adapter Tee With
Power P/N 115-0171-368 to a clean battery ground.
9
To Next Page
Loading...