Chapter 9
172 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Using Zone Maps
An AccuBoom zone map may contain numerous spray and no-spray zones for each field. Zone maps may be
modified at any time using the available tools and features of the zone mapping mode. The following sections
will cover various methods of using zone maps and field boundaries stored on the field computer.
Loading a Field Boundary
A field boundary recorded without the AccuBoom feature enabled may be loaded as an AccuBoom field
boundary within a zone mapping enabled job. To load a standard field boundary into an AccuBoom enabled
job:
1. Touch the Menu icon in the lower, right corner of the Guidance screen.
2. Select the Zone Mapping Tools icon.
3. Select the Load Field Boundary icon.A list of available field boundaries currently saved on the
field computer will display.
4. Select the name of the desired field boundary and touch the Accept icon. The selected field
boundary is displayed on the Guidance screen.
Note: Field boundaries created or exported by the Envizio Pro will be named using the job name or zone
map name provided when the job was started. Shapefile boundaries may be renamed on a PC or
laptop before importing the boundary onto the field computer.
To Next Page
Loading...
