CHAPTER 4
18 AGCO RoGator C-Series RG900, RG1100, RG1300 Hawkeye® Installation Manual
2. The locations listed below require that the Hawkeye
®
NCV is installed in the rear position and the ProStop-E is
in the forward position, closest to the boom tube:
• Just below the secondary boom fold cylinder, base end.
FIGURE 6. Cylinder Base End Installation
• The last nozzle body before the break away section.
FIGURE 7. Break Away Section Installation
BUMPER INSTALLATION FOR C-SERIES MACHINES WITH PROSTOP-E VALVES AND WILGER NOZZLE BODIES
1. Locate the boom stops and remove the existing hardware. Keep the existing washers and nuts.
To Next Page
Loading...
