CHAPTER
6
P/N 016-0171-655 Rev. D 31
CHAPTER 6
CHASSIS CABLE INSTALLATION
CHASSIS CABLE ROUTING AND CONNECTION
BEST PRACTICES AND RECOMMENDATIONS
• Do not connect battery leads until all cables are installed and connected.
• Route chassis cabling along existing cabling or plumbing to help avoid pinch points or stretching the cable
during normal equipment operation.
ELECTRICAL BOX CONNECTIONS
1. Locate the single, round connector on the supplied chassis cable (P/N 115-7303-310).
2. Route this connector to the electrical box and connect to the Hawkeye
®
bulkhead cable receptacle secured
previously.
3. Connect the chassis cable to the round receptacle on the Product Controller II ECU cable already installed in the
electrical box.
FIGURE 1. Chassis Cable Electrical Box Connection
CENTER RACK ROUTING AND BOOM CABLE CONNECTIONS
1. Route the round connectors labeled “left boom” and “right boom” toward the center rack of the machine.
2. Use the provided zip ties to secure the chassis cable to the undercarriage as necessary to avoid snagging the
cable during machine operation.
3. At the rear of the applicator tank, route the chassis cable so it follows the chemical supply lines underneath the
rear catwalk and through the center rack framework. Follow the supply lines to ensure adequate slack for
operating the center rack during field operations and when folding and unfolding the booms.
To Next Page
Loading...
