6
P/N 016-0171-655 Rev. D 33
CHASSIS CABLE INSTALLATION
FIGURE 3. Hawkeye Power Connection (No Injection)
NOTE: If the system will include Sidekick Pro™ ICD injection, a secondary fuse panel is required. The injection
pumps and Hawkeye
®
will be powered via the secondary fuse panel. Refer to “Sidekick Pro™ ICD
Installation” section on page 37 for additional information.
3. Connect one the M8 x 1.25 output studs to the power supply.
4. Connect the ground wire to the ground stud located on the bottom side of the rear catwalk.
FIGURE 4. Ground Connection
SYSTEM DIAGRAMS
Diagrams start on the next page.
AMI Fuse
Power
Connections
To Next Page
Loading...
