Cable and Connector Maintenance: Hawkeye Boom Harness Connector Maintenance 43
CABLE AND CONNECTOR MAINTENANCE
7. If not already applied, apply a single short burst of corrosion inhibitor (Corrosion X HD (Raven P/N 222-0000-
020 or available from http://www.corrosionx.com/corrosionx-heavy-duty.html)) into the NCV connection. Be
sure the corrosion inhibitor has coated the NCV contacts and recessed portions of the connector.
NOTE: To determine is corrosion inhibitor has been applied, inspect for a thick liquid in the bottom of the
connector (as shown in the Corrosion Inhibitor Applied image below).
NCV Connector
Applying Corrosion Inhibitor
Spray in
Void
Between
Pins
Corrosion Inhibitor Applied
To Next Page
Loading...
