Raven Hawkeye - Page 10

To Next Page

To Previous Page

CHAPTER 1

viii Hawkeye Nozzle Control Operation Manual

• 1 inch = 25.4 mm or 2.54 cm

• 1 mile = 1.609 km

Length Pressure

Main Page

Hawkeye Nozzle Control Operation Manual1
- Calibration Reference Sheet7
  - 1.7
  - 2.7
  - 3.7
  - 4.7
  - 5.7
  - 6.7
  - 7.7
  - 8.7
  - 9.7
  - 10.7
  - 11.7
  - 12.7
  - 13.7
  - 14.7
  - 15.7
  - 16.7
- Unit Definitions and Conversions9
  - Unit of Measure Definitions9
  - Unit of Measure Conversions9
Important Safety Information11
- Instructions for Wire Routing12
- Instructions for Hose Routing13
Introduction17
- Hawkeye™ Features18
- Care and Use20
System Calibration21
Hawkeye™ Nozzle Control and Sidekick Pro ICD Setup35
- Hawkeye Tools Menu Overview35
- Tools Menu Settings Definitions36
Hawkeye Operation53
Tally Registers65
- Using the Tally Registers65
- Tally Register Definitions66
Hawkeye Nozzle Control Valve Diagnostics67
- Nozzle Control Valve Diagnostic Definitions67
Troubleshooting71
Avoiding Skips with Hawkeye Nozzle Control System81
- Overview81
  - Recommendations for Hawkeye Nozzle Control Operation81
  - Causes of Skips using Hawkeye Nozzle Control83
- Tip Selection and Application Speed Guide85
  - Drift Control85
    - TABLE 1. Nozzle Drift Control by Manufacturer.85
    - TABLE 2. Table Key86
  - Application Speed Guide86
    - TABLE 3. Speed Table for Standard (Straight) Style Nozzle Bodies (Imperial)87
    - TABLE 4. Speed Table for Standard (Straight) Style Nozzle Bodies (Metric)88
System Diagrams91
Calibration Values99
Maintenance Schedule and Replacement Parts101
Storage and Start-Up Checklist113
- Hawkeye Storage and Start-Up Checklist113
Hawkeye Flowchart117
- Hawkeye Flowchart117
Remote Diagnostics Application125
- Application Screens125
Settings and Help Screen Terminology131
- TABLE 1. Setting and Help Screen Terminology131

Raven Hawkeye - Page 10

Table of Contents

Other manuals for Raven Hawkeye

Related product manuals