APPENDIX
D
P/N 016-0171-584 Rev. D 91
APPE NDIX D
MAINTENANCE SCHEDULE
AND REPLACEMENT PARTS
TECHNICAL SPECIFICATIONS
TABLE 1. Hawkeye Nozzle Control Valve Technical Specifications
HAWKEYE NOZZLE CONTROL VALVE MAINTENANCE
TABLE 2. Maintenance Schedule
U.S. Metric
Dimensions
Height 3.8 in. 9.65 cm
Width 1.39 in. 3.53 cm
Depth 1.35 in. 3.43 cm
Weight approximately 7.1 oz.
approximately 0.2 kg
Power
Operating Voltage
13.6 V DC nominal
(10 V drop-out to 16 V spike tolerant)
Input/Output
CAN CANBUS 2.0 Compliant
Switched (In/Out) 3V
Environmental
Operating
Conditions
-22° to 140° F -30 to 60° C
Storage Conditions -40° to 158° F -40° to 70° C
Relative Humidity 10 to 95% relative
Inspection Frequency Procedure
Walk-Around
Inspection of System
Cables and
Components
Weekly/as
needed
1. With the system power on, ensure all Hawkeye NCV LEDs
are flashing. If not, check the cable connections to the NCV’s
and the fuses in the fuse block located near the boom on
the chassis cable harness.
2. Verify the boom cables are securely fastened to the boom
and are not hanging below the lower boom tube.
3. Inspect each NCV for damage and proper installation on
the nozzle bodies.
4. Verify that the Hawkeye CANbus terminators (located on
the boom cables on each boom tip) are present and
securely tied to the boom cables.
To Next Page
Loading...
