CHAPTER
2
P/N 016-0171-584 Rev. D 7
CHAPTER 2
INTRODUCTION
The Hawkeye® Nozzle Control System is designed to provide PWM product rate and nozzle control via an
ISOBUS virtual terminal (VT). Adding the Hawkeye control system to an existing ISOBUS product control system
will allow a machine operator to monitor and control product application rate and pressure independently directly
from the VT without additional displays, controllers, or consoles.
This document is intended to provide information regarding the following aspects of the Raven Hawkeye nozzle
control system:
• Initial Setup and Navigation
• Calibration
• Hawkeye System Operation
• Hawkeye Operation When Used With Direct Injection
• Updating Hawkeye Components
NOTE: Prior to using the Hawkeye control features with any VT display, the Hawkeye Electronic Control Unit
(ECU) must be calibrated for the control system. Refer to Chapter 3, System Calibration, for assistance
with completing the initial calibration wizard.
This manual assumes that the required control hardware is already installed on supported equipment
and is properly connected. Contact a local Raven dealer for additional information on supported
equipment configurations.
To Next Page
Loading...
