Raven Hawkeye - 2. Select the Product Setup tab.; 3. Locate the pump number corresponding to the product pump.; 4. Using a 9;16” Allen wrench, loosen the outlet valve cartridge on the top of the pump adjacent to the transducer to release pressure at the injection pump outlet port. Use caution as there is potentially hazardous chemical inside the injection pump.

CHAPTER 3
18 Hawkeye Nozzle Control Operation Manual
FIGURE 8. Sidekick Pro ICD Button
2. Select the Product Setup tab.
FIGURE 9. Product Setup
3. Locate the pump number corresponding to the product pump.
4. Using a 9/16” Allen wrench, loosen the outlet valve cartridge on the top of the pump adjacent to the transducer
to release pressure at the injection pump outlet port. Use caution as there is potentially hazardous chemical
inside the injection pump.
WARNING
Fluid in the injection pump may be under
pressure, even if the system has not been in use
recently. Always wear protective equipment and
use caution when opening a system that has
been previously pressurized.