4
P/N 016-0171-584 Rev. D 31
HAWKEYE™ NOZZLE CONTROL AND SIDEKICK PRO ICD SETUP
• Reset Defaults - Select the reset defaults button to restore the default system settings. All user
settings will be reset and the initial calibration wizard must be completed before operating the
Sidekick Pro ICD injection system.
SYSTEM SETTINGS TAB - USER SETTINGS
To access the User Settings Menu:
1. Open the VT Menu and select the Hawkeye Menu button.
2. From the home screen, select the Tools Menu softkey along the right side of the display.
3. Select the System Settings tab along the top of the display.
4. Select the User Settings button. The following settings may be viewed or modified:
DISPLAY SMOOTHING
Enable Display Smoothing to display target rate as actual rate when the rate is within 10% of the target rate. Actual
rate will be displayed if the rate controller does not reach control deadband within ten seconds.
AUTO SECTION CONTROL
Allows Hawkeye to control sections in reference to coverage maps. When enabled, section control will
automatically turn off an active section as it enters an area where product has been previously applied. As the
section leaves the previously applied area, the section control feature turns the section back on.
NOTE: A task controller or VT capable of automatic section control is required to allow the Hawkeye system
to control sections automatically. Refer to the manufacturer operation guides and materials for
information on utilizing this feature.
• If the VT is capable of automatic section control and the section control feature is available in the Hawkeye
Tools Menu, select the feature by placing a check mark in the corresponding box to enable the feature.
• If the VT is capable of automatic section control, but the section control feature is not available in the Hawkeye
Tools Menu, the feature must be enabled from a different VT menu. Review the VT operation manual for
assistance with the section control or task controller options.
• If the VT is not capable of automatic section control, Hawkeye will not automatically control sections regardless
of the state of the section control feature on this screen. It is recommended to de-select or disable this feature
when operating the Hawkeye system without automatic section control.
EXTERNAL/RX CONTROL
Enable to allow the field computer (if equipped) to modify target application rate based on prescription map and/
or the task controller on-screen rate entry fields.
• Display Smoothing • Auto Section Control
• External/RX Control • PWM High Side Drive
• Enable Turn Compensation • Calibrate Turn Compensation
• Override Seconds • Enable Wireless Control
• Implement Switch • Speed Cal
Hawkeye
Menu
Tools Menu
System
Settings
User
Settings
VT Menu
User Settings
To Next Page
Loading...
