Raven Hawkeye - System Information Tab; 1. Open the VT Menu and select the Hawkeye Menu button.; 2. From the home screen, select the Tools Menu softkey along the right side of the display.; 3. Select the System Information tab along the top of the display. The following information will be available:

To Next Page

To Previous Page

CHAPTER 4

42 Hawkeye Nozzle Control Operation Manual

SYSTEM INFORMATION TAB

To access the System Information Menu:

1. Open the VT Menu and select the Hawkeye Menu button.

2. From the home screen, select the Tools Menu softkey along the right side of the display.

3. Select the System Information tab along the top of the display. The following information will be available:

This information is for display purposes only and may be useful when contacting technical support.

RESET DEFAULTS

Select the reset defaults button to restore the default system settings. All user settings will be reset and the initial

calibration wizard must be completed before operating the Hawkeye nozzle control system.

FEATURE UNLOCKS

Unlocks allow the user to activate features through the use of an activation key. Unlocked features are visible on

the feature unlock screen. Contact a Raven dealer for information on acquiring feature unlocks.

SERVICE MENU

Provides advanced features and options to assist with systems diagnostics or tuning the Hawkeye nozzle control

system. The service menu should only be used by a trained Raven service technician.

Contact a local Raven dealer for assistance with the Hawkeye nozzle control system if necessary.

• ECU Hardware Part Number • Software Part Number

• Hardware Serial Number • Bootloader Version

• Software Version • Total Hours

• Version Hours • Total Hours

• Total Runtime Hours • Wireless

•CAN Address •Wireless ID

• ECU Revision

Hawkeye

Tools Menu

System

Information

VT Menu

Other manuals for Raven Hawkeye