CHAPTER 4
24 ISO AutoBoom® Installation Manual for Case IH 3230, 3240, 3320, 3330, 3340, 4420, 4430, & 4440 (MY2010 &
CONNECT THE SENSOR CABLES
1. Connect the left sensor extension cable (P/N 115-0171-527 or 115-0230-051) to the connector on the left sensor.
2. Route the left sensor cable toward the AutoBoom valve.
3. Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.
4. Repeat the steps above to connect the remaining sensor cables.
NOTE: The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.
To Next Page
Loading...