Troubleshooting: Diagnostic Trouble Code (DTC) List 65
TROUBLESHOOTING
520593
.5 NB HS current low multiple
1. Reduce operating speed.
2. Verify the NCV voltage is above 10.5v.
3. Check the system cabling for damage.
4. Check the NCV duty cycle for proper
operation.
1. Contact a local Raven dealer if the issue is not
resolved.
.6 NB HS current high multiple
1. Reduce operating speed.
2. Verify the NCV voltage is above 10.5v.
3. Check the system cabling for damage.
4. Check the NCV duty cycle for proper
operation.
1. Contact a local Raven dealer if the issue is not
resolved.
523008
.2
Nozzle calibration tip mismatch/
error
1. Select the appropriate tip type. Refer to the
Injection Pump Efficiency section on page 46
for additional assistance.
2. Restart the calibration wizard to reset the tip
type setting for the nozzle control system.
3. Cycle system power and reset defaults.
.31 No NCV tip size selected
1. Enter a NCV tip size into the calibration
summary tab.
523009 .2
Nozzle calibration spacing
mismatch/error
1. Restart the calibration wizard to re-enter the
tip spacing measurement.
2. Cycle system power.
3. Reset defaults.
523088
.12 Nozzle memory error (single)
1. Restart the calibration wizard.
2. Cycle system power.
3. Reset defaults.
4. Contact a local Raven dealer for additional
assistance.
.31 Nozzle memory warning (single)
1. Restart the calibration wizard.
2. Cycle system power.
3. Reset defaults.
4. Contact a local Raven dealer for additional
assistance.
523089
.12 Nozzle memory error (single
1. Restart the calibration wizard.
2. Cycle system power and reset defaults.
3. Contact a local Raven dealer for additional
assistance.
.31
Nozzle memory warning
(multiple)
1. Restart the calibration wizard.
2. Cycle system power.
3. Reset defaults.
4. Contact a local Raven dealer for additional
assistance.
Code ID Description Recommended Actions
To Next Page
Loading...
