Raven OmniSeed Viper Pro - Page 68

Chapter 4
56 OmniSeed™ Viper Pro™ Installation & Operation Manual
4. To determine the offset direction, at the pivot point and facing toward the front of the vehicle, is the antenna
in front (fore) or behind (aft) of the pivot position? Select the direction of the fore/aft offset.
5. Measure the distance from the pivot point to the center of the front axle.
6. Measure the distance from the pivot point to the center of the rear axle.
7. Measure the distance from the pivot point (center of track length) to the control point or hitch.
8. Touch the Next button and continue to the Cart Setup section on page 56 or the Drill Setup section on
page 57.
Cart Setup
Note: The Two Wheel or Four Wheel Cart Setup screens will only display if the Seed Cart in Front of
Drill option was selected on the Seeder Configuration screen. Touch the Prev button to return to
previous screens and select this option if necessary. Refer to the Two Wheel Cart Setup section on
page 56 or the Four Wheel Cart Setup section on page 57 for additional assistance.
Two Wheel Cart Setup
Note: A two wheel cart has a single pivot point at the center of the cart axle.
1. Enter the length from the cart hitch to the cart pivot point. The hitch length must be measured perpendicular
to the cart axle.
2. Measure the distance from the pivot point to the cart control point or hitch.
3. Touch the Next button and continue to the Drill Setup section on page 57.