Raven OmniSeed Viper Pro - Page 75

4
Manual No. 016-3001-015 Rev. C 63
Initial Set Up and Navigation
For Example:
Given the following drill configuration as shown in Figure 5 on page 63:
• Overall implement width equals 600 in. [1524 cm].
• Three granular bins (three sections at the full implement width centered at the middle of the
implement).
• Two liquid products
• Five sections per liquid product with equal section widths equal to 120 in. [304.8 cm].
FIGURE 5. OmniSeed Section Numbering
The section mapping for the OmniSeed sections should be entered as shown below:
The above mapping values will allow each granular product or section to be toggled off or individually. The
display character of zero will help differentiate the granular air cart sections in the section status indicator area
at the top of the screen.
Air Seeder
Drill
2
13
49
810
11 13
12
7
6
5
x
x
x
x
xx
xx
x
x
xx
x
(‘x’ indicates
the midpoint of
each section)
Granular Product Sections
(Full Implement Width)
Liquid Product Sections
|
0
|
-60
|
-120
|
60
|
-180
|
-240
|
-300
|
300
|
240
|
180
|
120
1
2
3
0
0
0
1
2
3