Raven OmniSeed Viper Pro - Page 78

Chapter 4
66 OmniSeed™ Viper Pro™ Installation & Operation Manual
6. Select the desired display characters for the liquid product sections for all liquid sections. The display
character value is displayed at the top of the display on the main screen during seeding operations.
The above example displays an OmniSeed configured with three granular sections ten liquid sections.
The above image shows the first sections on the left of the implement for both products 1 and 2 are toggled
on. Both sections use the display character ‘1’ to indicate the first section for each product. The above
image also shows subsequent liquid sections grouped in this way.
Note: Carefully consider the section configuration for each liquid product before grouping display
characters as shown above. If sections do not over lap coverage or if one product is configured
with several control sections, it may be necessary to make adjustments to the display character
example shown above.
7. Use the on-screen keypad to enter the desired Switch Number for sections or section groups. The Raven
CAN switch box only provides 10 section switches for OmniSeed section control functions from the cab. For
systems controlling multiple sections with liquid products, it will be necessary to group sections to the same
switch.
For Example:
To continue the previous example, the following mapping has been completed for granular sections and the
‘Wired As’ values for both liquid products.
The display character values and the switch number assignment is highly flexible for the implement
configuration or the operation needs. The following images are an example of the completed Mapping
Sections screens for the
1
2
3
0
0
0
1
2
3
4
5
7
8
9
10
11
12
6
13
1
2
3
0
0
0
1
2
3
4
5
7
8
9
10
6
11
12
13
1
2
1
2
4
5
4
5
36
4
5
3
4
5
7
8
6
7
8