Chapter 4
76 OmniSeed™ Viper Pro™ Installation & Operation Manual
Bin Pressure and Fan RPM Display
The monitored fan RPM is displayed on the Main screen.
Review the Bin Pressure Sensor Calibration section on page 47 or Fan Cal section on page 52 for information
on calibrating and setting options for the bin pressure or fan RPM display. Up to four displays may be shown in
this area on the Viper Pro main screen for monitoring during field operations.
Map Area and Tab Views
The map area displays the current GPS location of the vehicle. This area may be used both in the field during
product application and when driving between fields to help identify target application areas for the operator.
The tabs displayed along the right side of the screen can be used to access different features of the application
currently in progress or display specific application or field feature information.
Note: Refer to the Tabs section on page 105 for detailed information on the tab displays and additional
features available from each tab view. Some tab views require additional features or system
components to enable operator access. Refer to Chapter 5, Using the OmniSeed Viper Pro
System, for details on starting jobs and enabling features during the job set up process. For
assistance with adding additional features to the Viper Pro, contact a local Raven dealer.
Main Tab. The Main tab is only available when the field computer is not providing guidance or logging
application or field data in an active job. The Main tab displays the current vehicle location with respect to
previously saved field boundaries or on a street map (if available) to help navigate between fields.
Note: Refer to the Street Maps section on page 169 for assistance loading street maps on the Viper Pro
field computer.
The Main tab view also displays the active profile at the top of the screen.
Guidance and Coverage Tabs. During an active job, the operator may select the tabs along the right side of
the screen to review guidance or application and field information logged during the current job in the map
area. Refer to Chapter 5, Using the OmniSeed Viper Pro System, for more details about the information
displayed using the tab views.
To Next Page
Loading...
