CHAPTER
3
Manual No. 016-0171-548 Rev. C 11
C hapter 3
Display Menus
Overview
Note: Prior to using the Phoenix 300, gently peel away the protective film covering the front panel
display.
The Phoenix 300 receiver is configured at the factory to operate in automatic mode. This allows the receiver to
begin operation quickly following initial installation. The front panel display allows the vehicle operator to
reconfigure the receiver, switch to an alternate differential source, and review performance statistics during
operation.
The keypad arrows are used to navigate through the display and configuration menus.
The following sections offer descriptions of the information displayed on the Phoenix 300 receiver front panel.
The following sections contain information about the menus and screen displays used to view GPS and
differential information during operation of the Phoenix 300 receiver. For information on configuring the
Phoenix 300 receiver, refer to Chapter 4, Configuration Menus.
To Next Page
Loading...
