4
Manual No. 016-0171-548 Rev. C 29
Configuration Menus
SBAS Configuration Menu
Access the SBAS Configuration menu to manually select the differential satellite PRN (pseudo-random noise)
value or allow the receiver to automatically select the differential satellite signal for corrections when using a
satellite based augmentation system (SBAS) correction source.
Press the key until the SBAS Configuration screen is displayed.
Current SBAS Configuration
Press the key and the current configuration is displayed.
Press the key and use the or arrow keys to manually select the PRN of the desired differential
satellite. Select a value between 120 and 138.
Press the key to select the displayed PRN number.
Note: The SBAS number is the satellite PRN currently used for differential corrections. If this screen
displays “SBAS AUTO” the Phoenix 300 will automatically select the satellite with the best signal
to noise ratio for differential corrections.
Setting the Phoenix 300 to Auto may cause the receiver to switch differential satellites during
operations.
To Next Page
Loading...
