4
Manual No. 016-0171-548 Rev. C 31
Configuration Menus
Beam
Press the key to view the current region, or beam, setting.
The beam identification is used to select the correct satellite for the region of operation.
Press the key and use the or arrow keys until the desired region is flashing on the screen.
Press the key to select the displayed setting.
The following service region identities are available on the Phoenix 300 receiver:
TABLE 2. Region Identities
Note: Visit the Raven web site below for additional information and assistance with the region beam
identities.
www.ravenhelp.com
ID Description ID Description
98W
North America and Western
South America
IOR
Eastern Europe and Africa, Asia,
and Western Australia
AORW
Eastern North America and
South America
143.5E Eastern Asia and Australia
AORE
Eastern South America, Western
Europe and Africa
POR
Eastern Asia and Australia and
Western North America
25E Europe, Africa, and Western Asia
To Next Page
Loading...
