4
Manual No. 016-0171-548 Rev. C 37
Configuration Menus
User Defined Frequency
To input a user defined frequency, set the User Defined option on the Service ID screen and press the
key. The Set User Defined screen will be displayed.
Use this screen to enter a satellite frequency (e.g. 1554.4970 MHz) and baud rate (e.g. 1200) supplied by
OmniSTAR for a User Defined configuration:
1. Press the key and use the or arrow keys to change the first digit in the frequency value.
2. Press the key to proceed to the second digit and repeat step 1 to set the second digit.
3. Repeat the above steps to enter each digit for the satellite frequency.
4. Press the when the frequency is displayed correctly and use the or arrow keys to select the
baud rate.
5. Press the key to set the baud rate and set the User Defined frequency.
To Next Page
Loading...
