System Setup: System Settings Tab 33
SYSTEM SETUP
NCV2 ERRORS
NOTE: Not available in the Bypass NCV2 control mode.
Displays any active NCV2 errors detected on the system.
NCV2 HEAT MAP
NOTE: Not available in the Bypass NCV2 control mode.
Shows an error status chart of the individual NCV2s. Review the NCV2 Status section on page 32 for details about
the NCV2 status displayed on the heat map.
SECTION HEAT MAP
Shows an error status chart of the sections. Review the Section Status section on page 32 for details about the
section status displayed on the heat map.
USER SETTINGS
To access additional operating and diagnostic features:
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the System Settings tab along the top of the display.
4. Select the User Settings button on the System Settings page. The following options are available:
AUTO SECTION CONTROL
Enable the Auto Section Control option to allow the ISO task controller to automatically control boom sections
based upon previous coverage maps to turn an active section when the section enters into an area where product
has already been applied. As a section leaves previously applied area, the section control feature will automatically
turn the section back on. When this option is disabled, section control commands from the task controller will be
ignored.
NOTE: A task controller capable of automatic section control is required to allow the RCM - Sprayer system
to control sections automatically. If the Auto Section Control is not enabled, section control
commands from the task controller will be ignored. Refer to the manufacturer operation guides and
materials for information on utilizing this feature.
• If the task controller is capable of automatic section control and the section control feature is available in the
RCM - Sprayer Tools Menu, select the feature by placing a check mark in the corresponding box to enable the
feature.
• If the task controller is capable of automatic section control, but the section control feature is not available in
the RCM - Sprayer Tools Menu, the feature must be enabled from a different UT menu. Review the UT
operation manual for assistance with the section control or task controller options.
RCM - Sprayer Menu Tools Menu System
Settings
UT Menu
User Settings
To Next Page
Loading...