Troubleshooting: General Troubleshooting 69
TROUBLESHOOTING
GENERAL TROUBLESHOOTING
4294967295
.1
Incompatible hardware
1. Reset defaults.
2. Recalibrate the system.
3. See Raven dealer for assistance.
NB unknown error single
1. Reset defaults.
2. Recalibrate the system.
3. See Raven dealer for assistance.
NB unknown error multi
1. Reset defaults.
2. Recalibrate the system.
3. See Raven dealer for assistance.
I2C init
1. Reset defaults and recalibrate system.
2. See Raven dealer for additional assistance.
Gyro sensor not initialized
1. Check the RCM - Sprayer ECU mounting
position and verify the RCM - Sprayer ECU is
securely mounted.
2. Recalibrate the RCM - Sprayer ECU gyro.
Accelerometer not initialized
1. Check the RCM - Sprayer ECU mounting
position and verify the RCM - Sprayer ECU is
securely mounted.
2. Recalibrate the RCM - Sprayer ECU gyro.
.31
Chemical tank is filling 1. The remote chemical tank fill switch is active.
Section control is not
unlocked
1. Verify section control is unlocked in the UT or
Task Controller. See UT or task controller
dealer for assistance.
Diagnostic application in
control
1. Verify a wireless device is in control of the
system.
Problem Action
Adjacent nozzle control valves pulsing at
same time.
•Check cabling connections.
•Check NCV2 diagnostics and DTC list for nozzle control valve
errors.
•Perform the Calibrate NCV2s test or Edit Profile to reindex the
nozzle control valves across the implement width.
•Contact a local Raven dealer for additional assistance.
Rate reads “0.” •Verify SPEED is registering accurately. If SPEED is zero, refer to
the UT display troubleshooting procedure.
•Verify TOTAL VOLUME is registering flow.
•Confirm the boom section status shows on the display changes
when section switches are activated in manual operation.
Code ID Description Recommended Actions
To Next Page
Loading...