Raven RS1 - System Health Tests

To Next Page

To Previous Page

Install SC1™/TC1™ with DirecSteer

4. Route the 12-pin connector from the DirecSteer power cable (P/N 115-8000-473) and

DirecSteer power harness (P/N 115-8000-060/315 or 115-8000-141) into the cab of

the machine.

Note: A harness extension cable (P/N 115-8000-214) is available if needed.

5. Connect the 2-pin Deutsch connector from the DirecSteer power cable (P/N 115-8000-

473) to the mating 2-pin connector on the DirecSteer main harness (P/N 115-8000-

474).

Other manuals for Raven RS1