16
5) Displaying Valve selections for PROD 1: 1-Sd (Injection Module/Standard Valve), 1-F (Fast Valve),
or 1-FC (Fast Close Valve).
a) Depressing momentarily
steps the DATA display from 1-Sd to 1-F.
b) Depressing momentarily
steps the DATA display from 1-F to 1-FC.
c) Depressing momentarily
steps the DATA display from 1-FC to 1-Sd.
6) Selecting a Valve for PROD 1 (1-Sd, 1-F, or 1-FC).
a) To select 1-Sd, 1-F, or 1-FC, step
until desired code is displayed.
b) Momentarily depress
. The DATA display will now display "2-Sd".
7) Displaying Valve selections for PROD 2: 2-Sd (Injection Module/Standard Valve), 2-F (Fast Valve),
or 2-FC (Fast Close Valve).
a) Depressing momentarily
steps the DATA display from 2-Sd to 2-F.
b) Depressing momentarily
steps the DATA display from 2-F to 2-FC.
c) Depressing momentarily
steps the DATA display from 2-FC to 2-Sd.
8) Selecting a Valve for PROD 2 (2-Sd, 2-F, or 2-FC).
a) To select 2-Sd, 2-F, or 2-FC, step
until desired code is displayed.
b) Momentarily depress
. The DATA display will now display "0".
The Console is now ready for the required Console Calibration programming to be entered.
NOTE:When entering data under the following keys, refer to the STANDARD DATA ENTRY
PROCEDURE detailed at the beginning of the INITIAL CONSOLE PROGRAMMING
section.
9) Procedure to enter BOOM CAL:
Definition of keys:
Depressing this key displays selected boom number in PROD 2 display window.
EXAMPLE: Boom 1 will be displayed as b-01.
Depressing this key after selecting BOOM CAL selects the next boom number.
EXAMPLE: b-01 will increase to b-02.
To Next Page
Loading...
