Chapter 5
36 Sidekick Pro Installation & Operation Manual
Injection Diagnostics Display
1. Touch within the product control area on the main screen.
2. Select the product node corresponding to the injected product and touch within data box 2 to display the
first Node Settings screen.
3. Press the Next button until the Injection Settings screen displays.
Cal Pump
Touch the “Cal Pump” button to start the injection pump calibration process.
Note: The injection pump should be primed before starting a pump calibration.
Prime Pump
Touch the “Prime Pump” button to prime the injection pump. The Viper Pro will stop the pump when the system
detects the pump has been primed.
Error Status and Solution
If any error conditions are encountered during an injected chemical application, the error type will be displayed
on the Injection Settings screen. Refer to Chapter 7, Troubleshooting, for detailed troubleshooting information
and solutions.
A brief description of the error code and solution is displayed in the solution area. Refer to Chapter 7,
Troubleshooting, for detailed troubleshooting information.
To Next Page
Loading...
