CHAPTER
7
Manual No. 016-0171-391 51
C hapter 7
Troubleshooting
Motor Control Node LED Status Indicators
The Sidekick Pro integrated motor control node displays the status of the injection pump with the following
node status indicators.
FIGURE 1. LED Status Indicators
TABLE 1. LED Status Indicators
LED Status Display
Logic Power
If logic power is present at the motor control node, the logic power indicator will be
on.
High Current Power
If high current power is present at the motor control node, the high current power
indicator will be on.
CAN Status
The CAN status indicator will flash once per second if the motor control node is
communicating on the CANbus. If the motor control node cannot communicate via
the CANbus, the CAN status indicator will flash four times per second.
Flow Switch State The flow switch indicator will flash once per revolution of the injection pump shaft.
Calibration Switch State
The calibration switch indicator will flash when a metal object is passed by the
calibration switch sensor.
Cal Switch State
Calibration
Switch
Flow Switch State
CAN Status
High Current Power
Logic Power
To Next Page
Loading...
