26
18) DATA-LOCK
Sequence to activate DATA-LOCK CODE (feature prohibits the entry of data without
first entering the DATA-LOCK CODE).
a) Display will show
PRESS ENTER FOR DATA-LOCK
. Press .
b) Display will show
NEW CODE E
.
c) Enter 4-digit code within 15 seconds.
(i.e. 1058, press and ).
Sequence to change DATA-LOCK CODE.
a) Press until display shows
PRESS ENTER FOR DATA-LOCK
. Press
.
b) Display will show
OLD CODE E
.
c) Enter 4-digit old code within 15 seconds and press . Display will
show
NEW CODE E
.
d) Enter 4-digit new code within 15 seconds or 0 to clear data-lock.
To enter mode sequence with activated DATA-LOCK CODE.
a) Depress the key in which data is to be entered. Depress . Code
message will appear.
b) Enter the DATA-LOCK CODE. If code is correct,
E
will appear. Now enter
data normally. The data lock may be cleared by entering 0 or by resetting
the console. To reset the console, place power ON/OFF switch to OFF,
depress and hold while placing the power ON/OFF switch to ON.
NOTE: The DATA-LOCK feature prohibits the entry of data without first entering
the DATA-LOCK CODE.
To Next Page
Loading...
