4
P/N 016-4001-133 Rev. B 27
ISO CALIBRATION & OPERATION
FIGURE 7. Home Screen
2. Toggle the master switch ON and verify that the control mode changes to AUTO.
NOTE: To return to AUTO mode from another mode, either press the AUTO button or cycle the master
switch OFF and then ON again.
• CENTER MODE - When the Steerable Hitch node is in CENTER MODE, the implement will align itself as closely
as possible to the calibrated zero position. To enable CENTER MODE:
FIGURE 8. Home Screen
1. From the Home Screen, ensure the master switch is activated under CONTROL MODE.
2. Toggle the master switch ON.
3. Select CENTER.
IMPORTANT: Once CENTER mod is used to shift the tongue, the steerable hitch system will maintain that tongue
position. To resume AUTO mode, toggle the master switch OFF and then ON again.
• BUMP MODE- When the Steerable Hitch node is in BUMP mode, the implement will move a fixed number of
degrees. The bump value is set in the Home Screen under Bump Rate. To enable BUMP MODE:
To Next Page
Loading...
