17
AccuBoom Setup
1. Touch the Booms Area.
2. Enter Look-Ahead values and touch Next.
3. Select the booms for AccuBoom automatic boom section control and touch
Next.
4. Select the desired aggressiveness setting and touch OK.
Note: The aggressiveness factor setting uses a percentage of the look-ahead
times to adjust the responsiveness of the AccuBoom system.
If a SwitchPro is connected to the Viper Pro, AccuBoom control is
controlled by the switch position on the Switch Box. Review the SwitchPro
instruction guide for more information.
To Next Page
Loading...
