7
Setting Application Rates
1. Touch the Application Rates Area.
2. Touch the desired Node or Channel to set/change.
3. Enter Target Rate. Touch Next to change other Nodes or OK to save changes
and close.
Note: Application Rates may only be modified on the Viper Pro if the field
computer is set as the CANbus controller. Product density and spreader
constant may also be modified when controlling a granular application
system.
4. Touch the Default Rate button to set a default rate for each product used with a
prescription map. The default rate will be applied to areas without prescription
information (i.e. outside of the prescription map area).
To Next Page
Loading...
