Manual No. 016-0171-122 Rev. I 169
Advanced Settings and Features
Configuring the Light Bar Display
When the on-screen or external light bar options are enabled, the Viper Pro field computer may be used to
configure the light bar display. These settings can help the operator set the accuracy of the light bar for
different operations or display preferences.
1. To configure the light bar guidance features from the Viper Pro, touch Menu, then Setup, Lightbar.
2. Touch the Next button. Review the on-screen description of the LED values and enter the desired distances
from the swath required to illuminate the light bar.
3. Standard light bar operation will illuminate the light bar in the direction of the guidance path from the current
vehicle position. In this mode, the operator will need to steer toward the lights to get back onto the guidance
path. To reverse the light bar display, select the Reverse LEDs option. This mode will require the operator
to steer away from the illuminated lights. Select the option that best suited for the operator.
Boom and Implement Setup
The applicator boom or implement section configuration is required to set up the Viper Pro system to monitor
or control product application. Refer to the Boom or Section Cal section on page 46 for a detailed description of
the boom or implement setup procedure.
8
To Next Page
Loading...
