CHAPTER 3
18 VSN Installation Manual for RBR Vector Ventuir/Vortex, MY18+
9. Connect the 23 pin connector to the back of the VSN Visual Guidance assembly.
FIGURE 14. VSN Visual Guidance Camera Connection
10. Use the provided cable clamps and ¼” hardware to secure the cable to the threaded studs on the VSN Visual
Guidance rectangular mounting arm, PN 116-0159-846.
a. Qty. 3 – 435-3001-043 – Cable Clamp.
b. Qty. 3 – 312-4000-164 – ¼”-20 Nylock Nut.
c. Qty. 3 – 313-2301-810 – ¼” Flat Washer.
INSIDE OF CAB
1. On the VSN Visual Guidance cable (P/N 115-2020-012), locate the connectors labeled “To V4 Video Port” and
“To V4 Video Tee.”
2. Route those connectors into the cab utilizing the floor cut out located on the bottom, right, rear corner of the
cab.
To Next Page
Loading...
