Note:
· Phones with cases more than 0.2 inch / 0.5 cm thick will not be detected. Remove
before charging.
Charging will start automatically with a right connection and the charging indicators
will light up accordingly.
Charging Indicators
Turns blue for 10 seconds,
then turns o
Turns on solid blue
Blue indicator turns o
Flashes red
Working Status
Standby
Charging a compatible device
Device fully charged
FOD (Foreign Object Damage)
alarm
Model
Input (Wireless Charger)
Output (Wireless Charger)
Powering the Wireless Charger
RP-SH013
5V / 2A, 9V / 2A
10W Max (Android)
7.5W Max (iPhone)
Caution
· The charging process may give o heat so your device will become warm. Use only
in cool environments.
· If the product gets wet, please stop the charging process immediately and remove
all plugs. Do not use it before it’s completely dry.
· Do not drop, knock, or squeeze the product.
· Do not dismantle or throw the product in re or water, to avoid causing short
circuit leakage.
· Do not use the wireless charger in severely hot, humid, or corrosive environments
to avoid circuit damage and leakage.
· Do not use the charger if it has excessive dents, punctures, damages, or deformities.
· Do not place close to magnetic stripe or chip card (ID card, bank cards, etc.) to
avoid magnetic failure.
· Make sure the back of your phone or phone case is even without foreign metal
objects.
· Keep at least 20 cm / 7.9 in away from implantable medical devices (pacemakers,
implantable cochlear, etc.) to avoid potential magnetic interference.
· Keep away from children.
05/06
To Next Page
Loading...