Raymarine 150 - Step 5: Install the Rudder Position Sensor; Rotary rudder position sensor - installation

22 Type 150/400 Autopilot System: Installation Guide
Step 5
Step 5: Install the Rudder Position Sensor
Note: Your autopilot system must include either a rotary or linear
rudder position sensor, otherwise it will not function.
Refer to the following installation instructions to fit either a rotary or
linear rudder position sensor:
5.1 Rotary rudder position sensor - installation
Introduction
The rotary rudder position sensor is suitable for all steering systems
apart from ‘bullhorn’ style hydraulic outboards (which require a
linear rudder position sensor - see page 26). The rotary rudder
position sensor connects directly to the boat’s tiller arm or quadrant.
Installing the sensor involves five main tasks:
• ensuring correct alignment
• securing the sensor to the boat
• attaching the sensor to the tiller arm
• checking alignment
• connecting to the course computer
Rudder position sensor - dimensions
5.1
Rotary rudder position sensor - installation page 22
5.2
Linear rudder position sensor - installation
(on ‘bullhorn’ style hydraulic outboards only)
page 26
140 mm (5.5 in)
187 mm (7.35 in)
70 mm (2.75 in)
60 mm (2.4 in)
D5386-1
81173_3.book Page 22 Thursday, June 7, 2001 11:51 AM