Raymarine Autohelm ST 30 - Chapter 6: Calibration; 6.1 Entry to calibration; 6.2 Depth units selection

Chapter 6: Calibralicn
Chapter 6: Calibration
6.1 Entry to calibration
The ST30 Depth can be programmed to display depth information in feet
or metres. To enter calibration, press and hold Diiy and %f After 2
seconds the display till show CM.
Each press of Display will cycle the unitthrough the calibration menu.
6.2 Depth units selection
1. Cycle Display until the display shows feet or meties.
2. Select feet or metres as required using A.