Base Station & Wireless Controller Installation Guide Base Station & Wireless Controller Installation Guide
Document number: 87042-2 Date: February 2005
Raymarine UK Ltd, Portsmouth, Hampshire, UK PO6 3TD +44 (0) 23 9269 3611
Raymarine Inc. Nashua, NH 03063-4219, USA Toll Free: 800-539-5539
+1 603-881-5200
Base Station & Wireless Controller Installation Guide
Self-tapping
screws
Base Station
Pozidriv screwdriver
Power Drill
Parts supplied
Tools Required
7
/
64
inch (2.7 mm) drill
1
/
8
inch (3.4 mm) drill
S100 REMOTE
MODE
STANDBY
PILOT
S100 Remote Smart Controller
Belt clip assembly
Lanyard
OR
Cradles x2
Cradles x2
3 Way
Connector
Block
SeaTalk Cable
Charging Cable
Ferrite
AAA batteries x2
STANDBY
PILOT
MODE
D7682-1
No. 6 size
No. 8 size
Min 3ft 3in (1m)
Locating Base Station
D7678-1
Fit as high up as possible, in a dry location
1.
3.
2.
1.
2.
D7675-1
3.
4.
Mark holes for the fixing screws.
Drill three
1
/
8
inch (3.4 mm) pilot holes
for the fixing screws
Fitting remote
Cradle at fixed position
Cradle on belt clip
Countersink the pilot holes to prevent
damage to the mounting surface.
To separate cradle from clip
C
l
i
c
k
Use the three No. 8 screws to secure
the cradle to the mounting surface
To Next Page
Need help?
General
