Chapter 2: Transducer Installation 31
Figure 2-3: Transom Mount Transducer Location
• Do not mount the transducer behind any hull fittings, intakes or other parts
extending from the hull that may cause turbulence or air bubbles.
• The bracket has a quick-release mechanism, shown Figure 2-4 . This allows
the transducer to flip up if it hits any debris or the bottom. Allow enough clear-
ance above the transducer for it to swing upwards completely – this is about
10" (254 mm), measured from the bottom of the transom.
Figure 2-4: Transom Mount Transducer - Quick-release Bracket
Be sure to allow at
least 2 in (50 mm)
beyond the swing radius
of the propeller
Approximately 18 in (457 mm) clearance
D4871-2
D4872-2
Transducer in
released position
Allow a clearance of
at least 254 mm (10 in)
To Next Page
Loading...
