50 DSM300 Installation Manual
2.6 Installing the In-hull Transducer
Tools and Material Needed
Tape
Pole
Detergent
Weak solvent (alcohol)
Safety goggles
Dust mask
Disc sander
Thin, sealable plastic bag (optional)
Twist-tie
Petroleum jelly (Vaseline®)
Level and protractor
Carpenter’s square
Pencil
Adhesive (Loctite #5699 or 3M #4200)
Screwdriver
Silicone grease (optional)
Mineral oil 2.4 fl oz. (71 mil)
Cored fiberglass hull installation:
Drill
Hole saw for hull interior 4" (100 mm)
Miniature disk sander
Casting epoxy (polyproxy #7035/7040) or resin
Paper cup
Stirrer
Testing the Selected Mounting Location
Establishing a Performance Baseline
The results of this test are used to determine the best in-hull location for a
transducer.
1. Take the boat to the maximum depth for which your instrument is rated, or the
maximum depth in which you will operate the sounder.
2. Connect the transducer to the DSM. Refer to
Transducer Cable Connections
on
page 26
.
To Next Page
Loading...
